Setup DMX signal with Luminex Node

ArtNet and RTTrPL first universe is 0; most console and sACN first universe is 1.

Set Luminex processor Input Source IP 0.0.0.0 will access any IP source.

Configure Luminex Node x cross fade:

1. Enter the Luminex node web interface

2. Select a processor, change processing type to "X-fade".

3. Change first input source to lighting console's address.

4. Change second input source to RTTrPL.

5. Select a Channel for cross fade control.

6. Select a X Fade Control Source.

7. Select the output destination of the processor.

Capture Control use absolute value to change Capture, advert that some console use percentage value.

Configure BlackTrax DMX Control channel:

1. Go to BlackTrax Application, select menu Settings > Project Properties

2. Set DMX Control source to lighting console's address.

3. Match the Merging Channel between Blakctrax and Luminex node X Fade Control Source.

4. Select a channel for Chapter Control.

5. Click Apply Changes on right button of the BlackTrax.