Initial Setup

Hardware Connection

1. Connect Sync Dock, Remote Charging Station and BTServer LAN port to same network.

2. Place BTBeacons to the Remote Charging Station; and MiniBeacons on the Sync Dock.

3. Connect TimeKeeper BNC output to eSync input 3. (Make sure Ferrite Filter is clipped on BNC cable)

4. (Optional) for MiniBeacons only, adding a BNC Splitter to split this BNC signal to the Sync Dock. (Make sure Ferrite Filter is clipped on BNC cable)

5. Connect BTRouter, TimeKeeper and eSync LAN port to same network as Step 1.

6. Launch Device Manager application to check Beacons connection.

7. Mounting the BTSensors to venues. connect BTSensors to same network

8. Launch Motive application to check sensors connections.

Create a new Portfolio

1. In Portfolio Manager, create a new portfolio.

2. Select the new portfolio and click Launch Portfolio.

3. Click Modules menu and select BT Engine to check the Engine status.

Software initial Setup

• Configure BTBeacons ID

• Setup Motive for BlackTrax

Lighting Fixture Control Setup

• Setup BTWYSIWYG

• Setup DMX signal with Luminex Node

• Preform Fixture Calibration

Chapter Programming